The Scorpion S-5035 series of motors are built with 8mm Titanium shafts that will last through countless hours of flying fun, but occasionally, on a "Less than Perfect" landing, you may bend or break one. For these occasions, we offer factory replacement shafts for all the Scorpion S-5035 Series Motors. Our Motor Shaft Kits include an original equipment factory shaft with a washer and a metric screw.

The shaft for the S-5030-220KV F3A motor measures 10mm in diameter, and is 118.6mm in long. The end of this shaft is ground down to 8mm to allow the user to install 8mm prop adpater.

Note: The shafts in the Scorpion motors are a slight press fit into the aluminum front housing. The shafts will not just slide out when the metric screw are removed. They need to be pressed out in a bearing press, or in a drill press, with the front housing of the motor supported in a block of wood to prevent warping the front housing.