Scorpion S-5028-220KV (F3A Limited Series)
Scorpion S-5028-220KV motor is specially designed for F3A and run on 10 Li-Po cells with props in the 19 to 20 inch range. Everything possible has been done on this motor to get the most possible power at the lightest possible weight. The Front housing, Bearing Tube and flux ring have been made as light as possible, and a Titanium Main Shaft is used to save even more weight, while maintain strength.
Scorpion Competition Series Brushless Motors are built from the best materials available, and are designed to provide both quality and performance at an affordable price. Scorpion starts with high quality aluminum alloy parts that are produced on the latest CNC milling machines. These parts are then gold Electro-Plated to provide a beautiful, long-lasting finish. The stators are made with 0.2mm laminations to give maximum efficiency, and minimum Eddy current losses. The stators are epoxy coated to prevent shorts, and are wound with wire that is rated at 180 degrees C (356 F). The magnets used in Scorpion Motors are rated for operation at 200 degrees C (392 F), making a motor that is virtually impossible to burn up in normal use.
Scorpion Motors are built to last, and are backed with a 2-Year warranty against defects in materials or workmanship. However, due to the high RPM of these motors, and the fact that we cannot control the installation and setup, the bearings are not covered by the 2-Year warranty, nor is any subsequent damage caused to the motor by a bearing failure. Bearings are a normal wear item, and as such, need to be maintained and changed periodically. For maximum life, make sure that a sufficient gap is left between the pinion and main gear during motor installation to avoid binding, and put a small drop of oil on each bearing every 5-6 flights. It is the responsibility of the pilot to ensure that the bearings are maintained properly.
For the best overall combination of quality, performance, and value, use Scorpion Motors in your planes.
|Stator Diameter||50 mm (1.56 in)|
|Stator Thickness||28 mm (1.10 in)|
|No. of Stator Arms||12|
|Motor Wind||11 Turn YY|
|Motor Wire||1-Strand 1.2 mm|
|Motor Kv||220KV RPM / Volt|
|No-Load Current (Io/10V)||0.98 Amps|
|Motor Resistance (Rm)||0.032 Ohms|
|Max Continuous Current||70 Amps|
|Max Continuous Power||2590 Watts|
|Weight||576 Grams (20.32 oz)|
|Outside Diameter||59.8 mm (2.35 in)|
|Shaft Diameter||7.98 mm (0.314 in)|
|Body Length||60 mm (2.36 in)|
|Overall Shaft Length||113.6 mm (4.47 in)|
|Max Lipo Cell||10s|
Weight including packaging